Loads one depth from each block into the spreadsheet. Blocks can be created by: Blocks can be created by: Time (Seconds) Distance (ft or m) # of Depths Loads one depth from each block into the spreadsheet. Slide 8 Read Parameters: Presort Window Divides each survey line into Blocks. Project Project Area Area Boat Boat Surveyor Surveyor Geodesy info from 1 st data file.Geodesy info from 1 st data file. Entries from SURVEYs Project Information window.Entries from SURVEYs Project Information window. Slide 7 Read Parameters: Survey Info Window Shows: Shows: Time and Date of the 1 st data file.Time and Date of the 1 st data file. Change the Position Offsets of a sensor.Change the Position Offsets of a sensor. Dangerous Dangerous Slide 6 Read Parameters: Offsets Window Changing offsets ONLY works when reading in RAW data files! Changing offsets ONLY works when reading in RAW data files! Change the Latency value.Change the Latency value. Snap to Line:Snap to Line: Moves soundings so they fall on the planned line.
Set Tide to Manual Entry in SURVEY Set Tide to Manual Entry in SURVEY To read Tide values that were manually entered during data collection. Slide 5 Read Parameters: Selections Window Select the equipment to be edited. Use Both, computes separate SV corrections, using the depths of the high and low frequency. Use Depth 2 computes an SV correction for both frequencies, using just the low frequency. Use Depth 1 computes an SV correction for both frequencies, using just the high frequency. Separate corrections can be computed for the high and low frequency depth values. After editing your data, run the SOUNDING ADJUSTMENT program. Using fixed corrections at different depths: Using fixed corrections at different depths: No entry is needed. Create a Sound Velocity Correction file (*.VEL) in the SOUND VELOCITY program.
Using a velocity probe: Using a velocity probe: Create a Sound Velocity Correction file (*.VEL) in the SOUND VELOCITY program. Slide 4 Correcting for Sound Velocity Sound Velocity Corrections Sound Velocity Corrections Calibrated sounder with a bar check: Calibrated sounder with a bar check: No correction file is needed. Specify telemetry tide device as Tide Device in Selection tab of Read Parameters. Specify Manual Entry in Survey as Tide Device in Selection tab of Read Parameters Specify Manual Entry in Survey as Tide Device in Selection tab of Read Parameters Telemetry Tides: Telemetry Tides: No entry is needed. Manual tides entered during SURVEY: Manual tides entered during SURVEY: No entry is needed. Set up RTK Tide parameters in Advanced tab of Read Parameters window. Enter the name of your file Enter the name of your file RTK Tides: RTK Tides: No entry is needed. Make a Tide Correction file (*.TID) in the MANUAL TIDES program. SINGLE BEAM EDITING HYPACK 2013 Slide 2 Data Flow Reads: Reads: Raw Data Files Old ALL Format Data Files ALL2 Format Data Files HSX (Multibeam EC1 records) Applies (optionally): Applies (optionally): Tide Correction Files SV Correction Files Saves: Saves: ALL2 Format Data Files (Default) Old All Format Data Files SBMAX Raw Data Files Old ALL Format Files ALL2 *.TID *.VEL Optionally: Read a single file, selected files from a *.LOG, or the entire *.LOG file Slide 3 Correcting for Tides Tide Corrections: Tide Corrections: Using a Tide Correction File: Using a Tide Correction File: Make a Tide Correction file (*.TID) in the MANUAL TIDES program.